This trainer is intended to study the characteristics of SCR, TRIAC, DIAC and MOSFET devices. In order to facilitate the experimental procedure, necessary support peripheral components like lamp load is provided on the system for interconnections. In order the observe various waveforms of the devices on oscilloscope, an external 12 AC reference is available on board. This trainer has all the necessary components like potentiometers, switches, Transformer, lamp load etc is provided. These are required to conduct all the experiment of the devices. Note: (a) An external current meter in the range of 25mA AC to 2A is required to measure respective currents, (b) a dual beam oscilloscope, and (c) a high impedance volt meter are essential requirements. Specifications: Thyristor : 1 No
The Thyristor used works on CLIP ASSEMBLY technology with
a) An average ON-State current of 10A @ 180? conduction angle.
b) Critical rate of rise of on-state current 50 A/ ?sec.
c) Peak gate current with 4A.
d) Average gate power dissipation 1 Watt.
e) Maximum peak reverse gate voltage 5 V.
f) Threshold voltage 0.77V.
g) Average gate power dissipation 1Watt.
- MOSFET : 1 No
- DIAC : 1 No
- TRAIC : 1 No
- Lamp load : 230 AC @ 100Watts and 12 DC @ 100mA lamp ? 1 each
- Potentiometers : Wire wound ? 3 Nos.
- Transformer : 12 AC @ 100mA for waveform synchronization.
- Resistor, capacitor, diode of assorted values
- Power :230 V AC @ 50 Hz
The entire instrument is housed in an elegant FRP cabinet. |
